T+A K2 Blu, Руководство пользователя, Страница: 17 / 90

17
Sub-point
Center
(This menu point only appears if
a Centre loudspeaker is
connected to the system)
Setting of loudspeaker type and cross-over frequency between the Centre
loudspeaker and the sub-woofer.
The procedure is as described under the menu point ‘L/R’.

 

 

If this menu point does not appear, even though a Centre loudspeaker is
connected to your system, please read the notes in the chapter entitled
‘Trouble-shooting’.
Sub-point
Subwoofer
In this menu point you can set the cross-over frequency for your sub-woofer. If
your system does not include a sub-woofer, you should choose the “OFF”
setting.
If a sub-woofer is present and you are using satellite loudspeakers, the same
cross-over frequency should be set here as in the previous menu point.
If you are using full-range loudspeakers which are supplied by a supplementary
sub-woofer in the deep bass range, we recommend the 40 Hz setting.
Sub-point
SPK A stand ....
Please select one of the LS A set-up options
free / near to wall / in a corner,
according to the location of your primary loudspeakers.
If loudspeakers are set up close to a wall or a corner, the result may be a
disproportionate boost to the low frequencies. To compensate for this effect the
K2 Blu features a corrective circuit which you can set in this menu point for the
main loudspeakers.
Sub-point
SPK B stand ....
(This menu point only appears if
loudspeakers are connected to
loudspeaker output B)
Settings as in the preceding menu point, but applicable to loudspeaker group B
Sub-point
2
nd
-room
(This menu point only appears if
loudspeakers are connected to
loudspeaker output B)
At this point you can determine whether loudspeaker group B is to form its own
listening zone with separate volume control.
If you choose the OFF setting, the volume of the ‘B’ loudspeakers is controlled
in tandem with the loudspeakers of group A (e.g. for two listening zones in one
room).
If you select the ON setting, the volume of the ‘B’ loudspeakers can be
controlled separately. This is only possible if you connect the E2000 external
remote control receiver (supplied in the accessory pack) to the machine, and
set it up in the second room.
      
For more information relating to modes of loudspeaker operation please refer to
the chapter entitled ‘Listening zones and bi-amping’.
Menu point
Video
(this menu point only appears
in conjunction with

TV Connect
)
This menu point opens a sub-menu where you can assign the audio inputs of
the
K2 Blu
to the video inputs of a video monitor. The
K2 Blu
then switches the
monitor on automatically when you select an AV source whose operation
requires it. When you switch sources, the monitor’s correct picture input is
selected automatically.
If your system includes a
Loewe - or Metz video monitor, use this sub-menu to
select the appropriate picture input of the monitor for each AV source which is
connected to the monitor (picture) and the
K2 Blu (sound).

 

 

This menu is only relevant if the K2 Blu forms part of a system which includes
a compatible Loewe or Metz monitor (television). This sub-menu is irrelevant if
no video monitor is connected to the K2 Blu . In this case the menu is not
displayed!
If your system includes a Loewe or Metz monitor, you will also need the TV
control lead with RS 232 connectors (TV Connect), available as an accessory
from

. (see '

TV Connect'
)