SySTIUM
®
TECHNOLOGIES
MODEL 133i
Copyright © 2013, Systium® Technologies, LLC
PN: 91601-00 Rev 01
ASSEMBLY GUIDE
Assembly Safety Instructions
Assembly of a computer system using this product shall be
assembled only by technically qualified personnel. Follow the
instructions in the
document “Model 133i Maintaining Regulatory
Compliance” to meet and maintain the safety and product
regulatory compliance of this product when assembling a
computer system using this product.
WARNINGS
Read and adhere to all of these instructions and
instructions supplied with this assembly. Failure to follow
these instructions will result in voiding the product
regulatory compliance statements. The computer system
will most likely be noncompliant with other regional
product laws and regulations.
The procedures in this document assume familiarity with the
general terminology associated with personal computers and with
the safety practices and regulatory compliance required for using
and modifying electronic equipment.
WARNINGS
TO PREVENT ACCESS TO HIGH ELECTRICAL
ENERGY PARTS, DO NOT REMOVE THE
COVERS WHILE THE SYSTEM IS POWERED ON!
Do not open the power supply. The power supply in this
computer contains no user-serviceable parts. To avoid
personal injury or damage to your equipment, refer repair
or replacement of the power supply to qualified technical
personnel only. All other areas and components of this
computer are considered user-accessible.
CAUTIONS
Electrostatic discharge (ESD) can damage disk drives,
add-in cards, and other components. Do the procedures
described in this chapter only at an ESD workstation. If
such a station is not available, you can provide some ESD
protection by wearing an anti-static wrist strap and
attaching it to a metal part of the chassis.
Motherboards can be extremely sensitive to ESD and
always require careful handling. After removing the board
from its protective wrapper or from the computer, place the
board flat on a grounded, static-free surface, component
side up. Use a conductive foam pad (if available) but not
the board wrapper. Do not slide the board over any
surface.
For proper cooling and airflow, always close the chassis
before turning on the computer system. Operating the
computer system without the chassis closed can damage
system parts.
This system after final integration will weigh 6 lbs or more.
Handle Carefully.
Before You Begin
1.
Be sure to follow each procedure in the correct order.
2.
Set up an equipment log to record the computer’s model
and serial numbers, all installed options, and other
information about the computer. This information must be
saved as a record of the
product’s configuration and
compliance with the allowable configuration options.
3.
We recommend that you use an anti-static wrist strap and a
conductive foam pad when working on the computer.
4.
You will need a Phillips (#1 and #2 bits) screwdriver and a
flat tip pliers for assembly
Unpack the System
Systium Technologies ships the Model 133i in
a reusable “End-
User ready
” single package.
CAREFULLY UNPACK THE COMPUTER
. Save the box and
packaging material for shipment to the customer. If components
are missing please contact your supplier or Systium
Technologies.
CONTENTS
The Model 133i System product contains the following:
•
Model 133i Chassis assembled with
o
200 Watt ATX Power Supply
o
Top and bottom panels
o
Momentary Power Switch,
o
Power LED
o
Dual 40mm Fan
o
6/32 x 1/4” Undercut Flat screws – Black-q3
•
North American Compliant Power Cord
•
Integration Kit
•
Quickstart Guide.
(This manual must be included in
shipment to the End User.)
•
Assembly Guide
FIGURE 1
