Systemline SN6210 S7, Инструкция по эксплуатации

Страница: 15 / 24

15
NAD T-Series
– There have been many T-series AV Receivers produced, so a definitive list
cannot be produced. NetLink is tested with T787, T785
It is highly recommended that you test the AVR compatibility with NetLink first before
installation.
2.
Amplifier Input:
Select the particular audio input that you have plugged NetLink into from
the drop down list. The list is different for each amplifier type and should reflect the inputs
available.
3. Interface Type: NetLink can control the connected AVR, turn it on / off, select the correct
input and control the volume in a convenient way, allowing the user to use the S7 App in the
same way as any other zone. NetLink can control the AVR using RS232 (dedicated control
port on the back) or IP. RS232 is recommended if available, so some AVR’s only support one
TCP/IP connection.
TCP/IP Setup:
4.
IP Address:
If IP interface type is selected then you must enter the IP address of the AVR. It is
recommended that you give the AVR a fixed IP so this does not change.
5.
TCP/IP Port:
This will be set automatically with the selected amplifier type, but you can
change this if required.
RS232 Setup:
6. Baud Rate: The correct RS232 baud rate will set with the selected amplifier type, but you can
change this if required
9.5 Zone Setup
1.
Zone Name:
Insert the desired name of the Netlilnk zone
Live Control:
2.
Live control:
Used to control NetLink over the Network, Standby, Source select and volume
Main Settings:
3.
Max Volume:
You can limit the volume level that NetLink will output, analogue output only
4. Alarm Volume: You can set a volume that NetLink will turn on from an alarm, this can also be
set from the App, applies to analogue output on NetPower mode only.
5.
TOV Mode:
Both sources can apply a turn on volume; use this drop down box to determine
when the turn on volume is applied
On each source Change = TOV is applied each time the source is changed
From Standby = TOV is applied only from standby, and the current volume is maintained
when switching sources.
6. Key Favourites: These relate to the front panel buttons and select stored favourites on the
server, set by the S7 App. The favourite number selected can be adjusted by inserting the
desired number.
7. Number of Keypads: You can select how many keypads you have connected to NetLink or
DigiLink by adding them by pressing the + button. Then you need to select the keypad mode
by pressing the KP button.
8.
Enable 192 kHz Output:
Tick this box if you have a AV amplifier capable of receiving a
192kHz sample rate, the coaxial digital output must be used and this option will also disable
the optical output.