Systemline 3 Output Music Serve, Инструкция по установке и эксплуатации

Страница: 16 / 48

PAGE 1
Section 3
•
Server User Guide
3.2 Powering the Server
ON and OFF
The Server has three separate power
states:
On – turn the Server on by pressing the
switch on the rear of the unit. You will see
the red LED illuminate on the front panel.
Press the STANDBY (
1 2 3
4 5 6
7 8 9
0
2
1
3
ABC
DEF
GHI
JKL MNO
PQRS TUV
WXYZ
) button next to
the red LED. The unit will begin its short
bootup procedure. You will see the LCD
illuminate and a Systemline welcome
screen on the TV/Monitor before the unit
arrives at the HOME SCREEN menu.
NOTE:
If you are using a PC display
attached to the VGA output and there is
no picture and the display is reporting
‘out of range’ or ‘no input’ and/or you are
experiencing a rolling picture or a black
and white picture on your TV, refer to
Display Settings (section 4.4.)
Standby – to put the Server into standby,
briefly press the front panel or handset
power button once. The unit will
immediately enter standby with the LCD
illuminated on its lowest setting and
showing the time. The video display will
turn off. In this state the Server is still fully
functional and will not have to go through
the bootup routine in order to come back
on.
Also during this time the unit will
automatically update its list of INTERNET
RADIO stations and if a compression
setting has been selected will compress
any uncompressed files. To turn the
Server back on press the front panel
power button or handset power button,
the unit will resume full operation
immediately.
Off –
to turn the unit off completely, press
and hold the front panel power button
for approximately 5 seconds, until the
LCD goes off and the red LED shows.
Alternatively you can simply move the
power switch on the rear panel to the OFF
position.
In this mode the unit will resume its last
power state when the mains switch is
turned back on again. This feature is
handy if there is a power outage while
the box is being used. When the power
returns the box will power back up in the
ON state. If it was in standby when the
outage occurred it will resume in standby
when power returns.