SystemBase uCAN View, Английская инструкция

Страница: 21 / 29

21
Control Bar
5.5. Setup
Click ‘Setup’ to open ‘uCAN Setup’ window.
(For more information regarding baudrate, please refer to chapter 10.1 Baudrate.)
Name Description
uCAN Serial
The name of current device can be changed. (Default: Serial1234)
영문이나 숫자로 최대 10자로 제한됩니다.
Preset CAN baud rate can be selected. (Default: 125Kbps)
Advanced Advanced options for baud rate settings (Default: Disable)
ClkDiv CAN baud rate - Clock Divider Register (Default: 1)
BTR CAN baud rate - Bit Timing Register (Default: 29)
SJW CAN baud rate – Synconization Jump Width (Default: 3)
TSEG1
CAN baud rate - TSEG1 is used to correct Phase Edge Error. May be
lengthened temporarily by synchronization. (Default: 6)
TSEG2
CAN baud rate - TSEG2 is used to correct Phase Edge Error. May be
shorten temporarily by synchronization (Default: 7)
ABOR
Enables ABOR (Automatic Bus-Off Recovery). (Default: Disable)
When error mode enters bus-off mode, ABOR function resets uCAN
device to restore the error count function. When reset, data loss
may occur.
ART
Enable ART (Automatic Retransmission) function. (Default: Disable)
While ART function is enabled, when CAN frame fail to transmit due
to ID priority conflicts or when error occurs, re-transmit will not
happen.