SystemAir SRC, Инструкция по установке и эксплуатации

Страница: 5 / 34

3 SRC
POWER SUPPLY MUST BE
SWITCHED OFF
BEFORE STARTING WORK IN THE
ELECTRIC CONTROL BOX
1. GENERAL RECOMMENDATIONS
Please read the following safety precautions very carefully before installing the unit.
1.1. SAFETY DIRECTIONS
Cutoff power supply before starting to work on the appliance.
The manufacturer declines any responsibility and the warranty becomes void if these instructions are
not respected.
If you meet a problem, please call the Technical Department of your geographical area.
The information contained in these Instructions are subject to modification without advance notice.
1.2. WARNING
Follow the safety rules in forces when you are working on your appliance.
The installation, commissioning, use and maintenance of these units should be performed by qualified
personnel having a good knowledge of standards and local regulations, as well as experience of this type
of equipment.
This appliance has not been designed for use by persons (including children) with reduced physical, sensorial
or mental faculties or by persons without any experience or knowledge of heating systems, unless they act
under the safety and supervision of a responsible person or have received prior training concerning the use
of the appliance.
Any wiring produced on site must comply with the corresponding national electrical regulations.
Make sure that the power supply and its frequency are adapted to the required electric current of operation,
taking into account specific conditions of the location and the current required for any other appliance
connected to the same circuit.
The unit must be EARTHED to avoid any risks caused by insulation defects.
It is forbidden to start any work on the electrical components if water or high humidity is present on the
installation site.
Climatic conditions
Transport
Ambient temperature -20... 70°C
Max. ambient humidity 95% RH, non-condensing
Storage
Ambient temperature -20... 70°C
Max. ambient humidity 95% RH, non-condensing
Operation
Ambient temperature -20... 50°C
Max. ambient humidity 95% RH, non-condensing
1.3. ENVIRONMENT
This equipment is designed for indoor installation ONLY.