SystemAir SRC, Инструкция по установке и эксплуатации

Страница: 30 / 34

1/2
Occ.
Occupancy
18.5°C
Setpoint
Auto
Speed
OFF
Status
Auto
Mode
WSHP
Address 1
1/2
0.0°C
Return air temperature
0.0°C
Indoor coil temperature
0.0°C
Leaving water temperature
0.0°C
Air probe
WSHP
Address 1
ON OFF
A
AUTO
05.02.2020
13:35
Zone 1
Home
18.5°C
Setpoint
High
OFF Cooling
Speed
Status Mode
No active alarms

i
System preferences
Unit information
Settings
Alarms
Scheduling
Air handling unit
Chiller
Fan coil
Menu
ON OFF
A
AUTO
05.02.2020
13:35
Zone 1
Home
18.5°C
Setpoint
High
OFF Cooling
Speed
Status Mode
2 active alarms

i
System preferences
Unit information
Settings
Alarms
Scheduling
Air handling unit
Chiller
Fan coil
Menu
Information
For type A fan convector unit zones, the communication alarms of the different units will only appear
when a value change is sent to them.
Information
If the heat pump on water circuit is not configured to use the temperature sensor on a remote
control, the value displayed in the “Air return sensor” field is equivalent to that in the “Air return
temperature” field.
28 SRC
The
SRC
is used to act individually on the following:
²
operating mode
²
unit status
²
ventilation speed
²
ambient setpoint(s)
²
in use/not in use
It is also possible to check the temperature measured by
the:
²
air return sensor (remote control sensor)
²
water flow sensor
²
evaporator unit sensor
²
air return sensor
8. ALARM
The SRC can report alarms on units. The information is displayed:
²
on the home page
the field specifies the number of alarms
²
on the menu
the “Alarms” menu is displayed in black if at least
one alarm is active