2
1. The compactness of the K..-EF series, plus the adaptability
to be mounted in any position, permits easy installation.
This straight-thru air flow fan can be mounted at any
angle from horizontal to vertical.
2. Because this unit has rotating parts, safety precautions
should be exercised during this phase of installation,
operation and maintenance.
3.
CAUTION:
For General Ventilation Use Only. Do Not Use
To Exhaust Hazardous Or Explosive Material and Vapors.
4. Remove unit from package and inspect within 15 days
after receipt. If damaged, report damage to carrier. Do
NOT operate this unit with visible damage to the blower
or impeller assembly.
5. For K...-EF Series fans, if bracket is used to mount fan,
refer to illustration 1. If suspending fan with hanger traps,
refer to illustration 2.
6. To attach duct work, use duct tape at inlet and outlet to
assure good seal. If using Systemair FK clamps: attach FK
clamps and insert screws through clamp into inlet and
outlet flanges.
CAUTION:
Use 1/2" sheet metal screws to secure duct
work to inlet and outlet. It is critical that the screw
penetrate the metal of the inlet flange but not so far as
to bind the impeller. It may be necessary to angle screws
away from impeller.
CAUTION:
If not using Systemair FK clamps use 1/4"
screws.
7. Screen guards must be installed when fan will be within
reach of personnel, within seven (7) feet of working area,
or when advisable for safety.
8. An appropriate duct termination device (roof cap, wall
cap, louvered shutters, etc.) are to be used with this fan.
1. WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS - OBSERVE THE FOLLOWING:
a. Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact your
manufacturer’s representative.
b. Before servicing or cleaning unit, switch power off at
service panel and lock the service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent warning device,
such as a tag, to the service panel
c. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
d. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
e. When cutting or drilling into wall and ceiling, do not
damage electrical wiring and other hidden utilities.
f. Ducted fans must always be vented to the outdoors.
g. If this unit is to be installed over a tub or shower, it
must be marked as appropriate for the application and
be connected to a GFCI (Ground Fault Circuit Interrupter)
– protected branch circuit.
h. NEVER place a switch where it can be reached from a
tub or shower.
Important safety information
Warnings
Содержание 40524
Страница 20: ...www systemair mx 404557 2016 11 03...
