D900-34-00
4
I56-1901-001R
©
2002 System Sensor
The horn and/or strobe will not work without power.
The horn/strobe gets its
power from the fire/security panel monitoring the alarm system. If power is cut off
for any reason, the horn/strobe will not provide the desired audio or visual warning.
The horn may not be heard.
The loudness of the horn meets (or exceeds) current
Underwriters Laboratories’ standards. However, the horn may not alert a sound
sleeper or one who has recently used drugs or has been drinking alcoholic bever-
ages. The horn may not be heard if it is placed on a different floor from the person
in hazard or if placed too far away to be heard over the ambient noise such as traf-
fic, air conditioners, machinery or music appliances that may prevent alert persons
from hearing the alarm. The horn may not be heard by persons who are hearing
impaired.
NOTE:
Strobes must be powered continuously for horn operation.
The signal strobe may not be seen.
The electronic visual warning signal uses an
extremely reliable xenon flash tube. It flashes at least once every second. The strobe
must not be installed in direct sunlight or areas of high light intensity (over 60 foot
candles) where the visual flash might be disregarded or not seen. The strobe may not
be seen by the visually impaired.
The signal strobe may cause seizures.
Individuals who have positive photic
response to visual stimuli with seizures, such as persons with epilepsy, should avoid
prolonged exposure to environments in which strobe signals, including this strobe,
are activated.
The signal strobe cannot operate from coded power supplies. Coded
power sup-
plies produce interrupted power. The strobe must have an uninterrupted source of
power in order to operate correctly. System Sensor recommends that the horn and
signal strobe always be used in combination so that the risks from any of the above
limitations are minimized.
The Limitations of Horn/Strobes
WARNING
Three-Year Limited Warranty
System Sensor warrants its enclosed horn. strobe, or horn/strobe to be free from
defects in materials and workmanship under normal use and service for a period of
three years from date of manufacture. System Sensor makes no other express war-
ranty for this horn, strobe, or horn/strobe. No agent, representative, dealer, or
employee of the Company has the authority to increase or alter the obligations or lim-
itations of this Warranty. The Company’s obligation of this Warranty shall be limited
to the repair or replacement of any part of the horn, strobe, or horn/strobe which is
found to be defective in materials or workmanship under normal use and service dur-
ing the three year period commencing with the date of manufacture. After phoning
System Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization
number, send defective units postage prepaid to: System Sensor, Returns Department,
RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please include a note
describing the malfunction and suspected cause of failure. The Company shall not be
obligated to repair or replace units which are found to be defective because of dam-
age, unreasonable use, modifications, or alterations occurring after the date of manu-
facture. In no case shall the Company be liable for any consequential or incidental
damages for breach of this or any other Warranty, expressed or implied whatsoever,
even if the loss or damage is caused by the Company’s negligence or fault. Some
states do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you. This Warranty gives you
specific legal rights, and you may also have other rights which vary from state to state.
Please refer to insert for the Limitations of Fire Alarm Systems
FCC Statement
NOTE: SpectrAlert Horns have been tested and found to comply with the limits for a Class B digital
device, and SpectrAlert Strobes and Horn/Strobes have been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a com-
mercial environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
firealarmresources.com
