System Sensor BEAM200, Инструкция по установке и обслуживанию, Страница: 10 / 15

D400-74-00 10 I56-2289-005R
Blinks output by Yellow LED and Remote Trouble Output
once the device has passed a local remote test:
Percent The Detector Has Drifted Number Of Blinks Output
<10% None
<20% 1
<30% 2
<40% 3
<50% 4
<60% 5
<70% 6
<80% 7
<90% 8
<100% 9
Modes *Red
See Note
Below
Yellow and
Remote Trouble
Output
*Green
See Note
Below
Remote
Alarm
Output
Dual Digital Display Initiating means Comments & Troubleshooting
Tips
Normal Off Off Blink Blink Off Successful completion
of initialization or
detector reset
Alignment Off On Blink Blink On, Relative amount
of signal 0-99, or – if
automatic gain resetting,
or Lo if signal is too low
Alignment Switch
Alarm On Off Off On Off Smoke, Test Filter,
RTS451 or RTS151
Test Stations
Trouble-Drift
Comp Elevated
Signal
Off 3 Quick Blinks Blink Blink Off Long Term Drift
Reference Out of
Range
• Sunlight into detector or reflector.
• Re-Align detector.
Trouble-Drift
Comp Reduced
Signal
Off 2 Quick Blinks Blink Blink Off Long Term Drift
Reference Out of
Range
• Clean detector and reflector.
Trouble-Signal
Over Range
Off 2 Quick Blinks Blink Blink Off Increase of Reflected
Signal
• Inspect line of sight between
detector and reflector for
reflective objects in the pathway.
Trouble-Beam
Blockage
Response
Off 4 Quick Blinks Blink Blink Off Beam Blockage • Remove blockage.
• Faulty unit.
Initialization-
Power on
Off Blink until
complete
Blink Blink Off Apply Power from
discharged state.
Initialization-
alignment exit
Off Blink until
complete
Blink Blink Off Depressing RESET
switch after alignment
Local Test
(BEAM-200S)
Pass Result
On Blinks out amount
of drift used
Off On Off Panel or RTS451/KEY
or RTS151/KEY
Remains in alarm until reset or
time-out
Local Test
(BEAM-200S)
Fail Result
Off On until reset or
time-out
Blink Blink Off Panel or RTS451/KEY
or RTS151/KEY test
input
Remains in fault until reset or
time-out
Local Test
(BEAM-200)
Fail
Off On until reset or
time-out
Blink Blink Off Panel or RTS451/KEY
or RTS151/KEY test
input
Remains in fault until reset or
time-out
Local Test
(BEAM-200)
Pass Result
On Blinks out amount
of drift used
Off On Off Panel or RTS451/KEY
or RTS151/KEY
Remains in alarm until reset or
time-out
Note: Green and Red LEDs are controlled by the control panel.
APPENDIx I. OPERATION MODES AND TROUBLEShOOTINg gUIDE: