Installation and Commissioning
Manual SCA-340 / SCA-340-L
sysmik.de
13
3.1.3
Adding Inline Terminals
An Inline station is assembled by plugging the individual components to each other,
thus establishing the potential and bus signal connection between the individual
components of the station. Figure 3.1.3.1 shows the procedure of mounting a
terminal.
Disconnect power to the entire station.
Mount the electronics base onto the rail (A). Adjacent terminals are
interlocked by their feather keys / keyways (B).
First insert the feather keys of the local bus into the keyways of the
preceding terminal (B1).
Guide the feather keys along the keyways until they lock appropriately
(B2).
Ensure that the feather keys are properly connected (C2). C1 shows the
common mistake that the feather keys are not inside their keyways.
After mounting all electronics bases install the connectors onto their
respective bases. First insert the front detent (D1). Then push the
connector onto the electronics base until the rear
detent locks properly
(D2).
Figure 3.1.3.1:
Installation on the mounting rail (A), connection of Inline components to each other (B),
connection check (C), plugging of the wiring level (D)
Note:
While connecting the components to each other and to the mounting rail later, please
make sure that all feather keys and latches are properly snapped in!
Note:
Please consult the User Manual with regard to configuration and installation of the
Inline product family (see [1]).
6452B010