Syris v300TM, Руководство пользователя

Страница: 9 / 121

8
www.syrisscientific.com
Syris Scientific, LLC
Product Setup
The following procedures may be used to adjust the headband and complete the
wiring setup for either the v300 or v600 Visualization System.
Headband Adjustment (Figure 3)
1) Begin by adjusting the height of the top strap of the Headgear. This strap is
adjusted by separating the strap and sliding it to a new position. The strap is
secured by locking the plastic buttons on the lower strap into the holes of the
upper strap.
2) Loosen the Headgear headband by pushing the knob at the back of the
headband and turning it counter-clockwise.
3) Position the Headgear on your head, ensuring that the front of the headband
sits comfortably above your eyebrows. If the Headgear sits too high or two low
on your head, repeat step one.
4) Tighten the headband by pushing the knob at the back of the headband and
turning it clockwise.
5) Adjust the position of the Visi-Shield by turning the knobs on either side of the
Headgear. When properly positioned, the magnifying lens should be in your
normal line of sight.
6) It is critical that the top strap of the headgear be adjusted to allow the
rear section of the headgear to fit below the protuberance at the base
of your skull! The system will be extremely uncomfortable without this
adjustment! See Fig. 3 below.
Figure 3. v300/v600 Headgear Adjustment