Syris v300TM, Руководство пользователя

Страница: 14 / 121

v300/v600 Owner’s Manual
Doc #5002 (English) 07/2004
13
v600 Illuminator Module Replacement
1) Turn off the v600 Visualization System and disconnect the AC Power Input
Cable from the wall outlet. Disconnect the Upper DC Power Cable from the
old Illuminator Module.
2) Allow the old Illuminator Module to cool at least ten minutes before
proceeding.
3) Remove the new Illuminator Module from the packing tube. Enclosed in the
packing tube is a cotton glove. Please use this glove for handling the new
Illuminator Module.
4) Remove the old Illuminator Module from the optics tube by rotating it counter-
clockwise as shown in Figure 5.
5) With a gloved hand, remove the new Illuminator Module from its plastic
wrapper.
IMPORTANT! Do not allow the Illuminator Module bulb or reflector to come
in contact with exposed skin or other foreign material. This may cause
premature failure of the Illuminator Module.
6) Install the new Illuminator Module in the optics tube by screwing it clockwise.
IMPORTANT! Do not force the new Illuminator Module into the optics tube.
If you are having difficulty installing the new Illuminator Module, rotate it
counter-clockwise one turn and then re-attempt to gently screw it into the
optics tube. Figure 5: Removal of v600 Illuminator Module.
7) Connect the Upper DC Power Cable to
the Illuminator Module, and plug AC
Power Input Cable into a wall outlet.
8) Turn the system on and make sure the
both the lamp and fan are functioning.
Figure 5. Removal of v600 Illuminator Module