Synway Information Engineering Co., Ltd
Figure 2-9 Front View
Figure 2-10 Rear View
2.3
2.3.1
Interface
Identification
It’s quite important to recognize different kinds of interfaces, as such information is necessary for
configuration of Asterisk platform. In real practice, not all interfaces on the board are used at a
same time. When to use which interface depends on the installed modules and their particular
positions on the board.
RJ11
Each FXM-8A/PCI board has 4 RJ11 jacks on the bracket and each jack connects with an
independent module interface (may be FXO, FXS or composite module). Jacks 1~4 from top to
bottom correspond to Modules 1~4.
A single board of FXM-8A/PCI can be equipped with up to 4 dual-channel modules and supports 8
voice channels. The pin layout of the 4-pin RJ11 jack is shown as follows.
Pin
Note
1 Tip2
2 Tip1
3 Ring1
4 Ring2
Table 2-1 RJ11
2.3.2 RJ45
Each FXM-16A/PCIe board has 4 RJ45 jacks on the bracket
A single board of FXM-16A/PCIe can be equipped with up to 8 dual-channel modules and
supports 16 voice channels. The pin layout of the 8-pin RJ45 jack is shown as follows.
Clamp
Hole
Model
Version
Date
Clamp
Hole
T&User
Ver:xx
xxxxxx
Clamp
Hole
Model
Clamp
Hole
T&User
Pin1
Pin4
Synway FXM series Hardware Manual
（
Version 1.0
）
Page 8
