Attachments
Ream Attachments
All UNIUM Reaming attachments provide a maximum
torque of approximately 6.0 Nm at maximum load and a
maximum speed of 340 rpm with no load.
Quick Coupling Ream Attachments
Inserting and Removing the Cutting Tools
To connect the cutting tool, pull the coupling sleeve back
and then insert the cutting tool while rotating slightly until
it locks in place.
To disconnect, pull the coupling sleeve back and remove
the cutting tool.
■ Note:
Adapters for Kuentscher (511.787) and
Harris (511.788) can be used in connection with
the AO/ASIF Quick Coupling (05.001.257).
The four attachments shown on the right replace the
legacy Colibri II/Small Battery Drive II attachments
(532.017, 532.018, 532.019 and 532.020) They are
designed to enable the use of reverse function.
Quick Coupling for DHS/DCS Triple Reamers
Inserting and Removing the Cutting Tools
To connect the cutting tool, push the coupling sleeve
forward and then insert the cutting tool while rotating
slightly until it locks in place.
To disconnect, push the coupling sleeve forward and
remove the cutting tool.
The DHS/DCS attachment can be used with the reverse
function.
Ream Chuck Attachment
Inserting and Removing the Cutting Tools
Open the jaws of the chuck using the appropriate key or
by hand. Insert the shaft of the cutting tool into the open
drill chuck and close it by twisting the chuck. Make sure
that the shaft lies central to the three jaws. Tighten the
drill chuck with the key. Make sure that the teeth of the
key engage correctly in the toothed rim of the chuck.
To remove the cutting tool open the chuck with the key.
The warnings for the Drill Chuck Attachment also apply
to the Ream Chuck Attachment. See page above.
AO/ASIF Quick Coupling (05.001.257)
Hudson Quick Coupling (05.001.258)
Trinkle Quick Coupling (05.001.259)
Trinkle Quick Coupling, modified (05.001.260)
DHS/DCS Quick Coupling (532.015)
Chuck, clamping range up to
B
7.3 mm (05.001.254)
Key (510.191)
19
UNIUM
™
• Instruction for Use
