Synetik ErgoCare Vertiflex 60, Руководство пользователя

Страница: 7 / 12

ADJUSTMENT PROCEDURE
5. ABDUCTION ANGLE ADJUSTMENT
To adjust the abduction angle, loosen the two knobs on each side and
gradually lift outward tothe required position. Retighten both knobs
on each side
(fig. 5a-b) .
6. POMMEL HEIGHT ADJUSTMENT
To adjust the height of the pommel you will need to use the Allen key located on
the side of the hydraulic cylinder. Loosen the set screw located on the right side
at the bottom of the stander core
(fig. 6) , then slide the pommel to the desired
height. Use the Allen key to firmly retighten the set screw.
7. HIP SUPPORT ADJUSTMENT
To adjust the height of the hip supports, loosen the wing knob and
the two other knobs located between the hip and knee supports
(fig. 7a) . Slide to the desired height and retighten the three knobs.
To adjust the width of the hip supports, loosen both wing knobs.
Slide to the required width, then retighten
(fig. 7b) .
8. THORACIC SUPPORT ADJUSTMENT
To adjust the height of the thoracic supports, loosen the two knobs
located in the upper part of the core
(fig. 8a) . Slide the top part
of the support up or down to the desired height and retighten. To
adjust the width of the thoracic supports, loosen the two knobs
on each side of the core and slide sideways to the required width
(fig. 8b) . Firmly retighten the four knobs.
9. SHOULDER SUPPORT ADJUSTMENT
To adjust the height of the shoulder support, use the Allen key and loosen the two
set screws
(fig. 9) . Adjust by sliding to the desired height and retighten with the
Allen key.
10. HEADREST ADJUSTMENT
To adjust the headrest height (upward), loosen the knob behind the shoulder rest,
slide the rod upward, and retighten the knob
(fig. 10) . To lower the height of the
headrest, proceed in the same way in addition to loosening the screw on the stopper
ring with the Allen key.
fig. 8a
fig. 8b
fig. 6
fig. 5a
fig. 5b
fig. 9
fig. 7b fig. 7a
fig.10