18 |
Setting SPOTTING time
Press button SET until you switch on lED marked in the picture.
Use the potentiometer to set required value of spot time 0.5-5 seconds.
Setting PULSE time
Press button SET until you switch on lED marked in the picture.
Use the potentiometer to set up required value of interval time between
particular 0.2-2 seconds.
Setting four-stroke welding mode
Press button FNC until you switch on lED.
Mode four-stroke is adjusted.
Setting four-stroke SPOTTING
Press button FNC until you switch on two lED four-stroke and SPOTTING in
the picture.
Mode four-stroke spotting is adjusted.
Setting four-time PULSE mode
Press button FNC until you switch on two lED four-stroke and PUlSE in the
pic.
Mode four-stroke pulse is adjusted.
function mEm
(only with machines PROCESSOR)
Function enables back recall and display of last welding parameters for a
period of about 7 seconds.
Press the button SET until the lED is on, marked in the picture.
SyNERGIC
Adjust the required value of the approaching speed of the wire shift with a
potentiometer within the range of 1 - 20 m/min.
NOTe 1:
Adjusted values will be stored automatically in memory after pre
-
ssing torch button for a period of about 1 sec.
NOTe 2:
Set values can’t be changed during welding, except speed of wire
shift.
function factory configuration
Function factory configuration is used for initial setting of all parameters for
controlling electronics. After you have used this function, all values will be
adjusted automatically on values pre-set by producer like with a new machi
-
nes. In other words, you restart controlling electronics.
Switch the main switch off. Press and hold button SET.
oFF
ON
Switch the main switch on. Release button SET. Display shows values of ini
-
tial adjustment.
Adjustment of welding mode
Controlling electronics of machines PROCESSOR and SyNERGIC enables wel
-
ding in the following modes:
• Smooth two-stroke and four-stroke mode
• Spotting and pulse in two-stroke
• Spotting and pulse in four-stroke
Setting up two-stroke welding mode
Mode two-stroke is set up when the machine is switched off and there is
no lED on such.
Setting two-stroke SPOTTING
Press button until you switch on lED SPOTTING in the picture.
Mode two-stroke spotting is adjusted.
Setting two-stroke PULSE
Press button until you switch on lED PUlSE.
Mode two-stroke pulse is adjusted.
18
EN
