Synapse DDP84, Инструкция по установке и эксплуатации

Страница: 17 / 37

17
Enc_config
With this setting you configure the encoder. The DDP84 supports multiple
output formats. This always sets the maximum amount of channels (so
metadata could change 5.1 to 2.0). Default setting is
5.1+2.
Normal encoder settings:
The following
Enc_config
settings are the normal settings. In the
following table you see which settings have what outputs.
Note
that DD(+)
means that the output is either Dolby Digital or Dolby Digital Plus,
depending on what settings have been done at the
Enc_mode
settings
which are next in the menu.
Setting Encoder out 1 Encoder out 2 Encoder out 3 Encoder out 4
2
DD(+) 2.0 - - -
2+2
DD(+) 2.0 DD(+) 2.0 - -
2+2+2
DD(+) 2.0 DD(+) 2.0 DD(+) 2.0 -
2+2+2+2
DD(+) 2.0 DD(+) 2.0 DD(+) 2.0 DD(+) 2.0
5.1
DD(+) 5.1 - - -
5.1+2
DD(+) 5.1 DD(+) 2.0 - -
5.1+1+1
DD(+)5.1 DD(+)1.0 DD(+)1.0 -
5.1+2 or
5.1+1+1
DD(+)5.1 DD(+)2.0 or
DD(+)1.0
- or DD(+)1.0 -
Transcode and auto-backup settings:
The following Enc_config settings are special settings when using the
bitstream input (either a physical Dolby digital input on input 5 or a Dolby
digital input via the Synapse bus). This signal is converted to Dolby
Digital Plus when using these settings. In case the Dolby digital signal is
lost, then the inserted PCM signals will be used in the defined way you
selected. For example: when the setting
2+2 or TC
is applied, the
Dolby Digital input is transcoded to dolby Digital Plus, but when the
Dolby digital input signal is lost, then the designated PCM inputs will be
converted to a 2x 2.0 DD(+) output automatically.
Setting Encoder out 1 Encoder out 2 Encoder out 3 Encoder out 4
2.0 or TC
DD(+)2.0 or TC - - -
2+2 or TC
DD(+)2.0 or TC DD(+)2.0 or TC - -
5.1 or TC
DD(+)5.1 or TC - - -
TC
TC - - -
Pro logic II settings:
The DDP is capable of encoding Pro Logic II
signals. Pro Logic II is a multichannel sound source down mixed to a
single stereo channel. The table and schematics on the following page
display and explain the 2 possible Pro Logic II settings.
Setting Encoder out 1 Encoder out 2 Encoder out 3 Encoder out 4
5.1+2+PL.0
(a) DD(+) 5.1 PLII DD(+) 2.0 PL II -
5.1+2+PL.1
(b)
DD(+) 5.1 PL II DD(+) 2.0 -