Symphony 110CR400A/W-L, Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 32

110 Series Ice and Water Dispensers 13
2. Remove dispenser top front cover by removing two screws at bottom corners of cover, lifting cover slightly and pulling
forward.
3. Remove ice machine compartment top and side panels.
4. Remove ice machine hold-down bracket from front of ice machine compartment.
5. Lift ice machine onto dispenser top and slide ice machine completely into position, compressor end fi rst. Front of ice
machine base must be fl ush with front of dispenser.
6. Reinstall hold down bracket on front of ice machine with power cord and bin signal cords in notch. Do not cut or pinch
cords.
7. Insert loose end of ice transport tube through bracket (on ice machine base) into hopper access hole. Be sure that transport
tube is secured under retainer on fl oat reservoir bracket (Step 2, Fig. 7). Tighten transport tube clamp screw to secure ice
transport tube.
8. Connect plastic water supply line to fi tting at top of fl oat reservoir.
1
2
3
TIGHTEN
CLAMP
SCREW
9. Connect vinyl drain line from dispenser securely to drain line on ice machine.
10. Connect ice machine two-lead bin signal twist lock plug, and three-lead power twist-lock plug, to dispenser twist-lock
connectors.
11. On dispensers equipped with water-cooled ice machines, connect condenser water supply and drain lines to
condenser fi ttings on ice machine.
12. Turn on water supply and check that water level in fl oat reservoir (when full) is within 1/4" (6mm) of mark on side of
reservoir and that fl oat moves freely.
13. Verify that water sensor tabs are immersed in water in reservoir. Check for leaks. Replace splash panel.
14. Plug dispenser power cord into 20A rated NEMA 5-20 wall socket.
15. If dispenser is equipped with SensorSAFE remove protective plastic coating form dispense sensor labels.
16. Turn on power and bin signal rocker switches and test operation.
17. Clean and sanitize ice machine following instructions in ice machine manual.
18. Remove dispenser hopper access lid and clean and sanitize dispenser according to instructions on page 14.
19. Replace front cover and secure with screws. Installation is complete.
Fig. 8 – Ice transport tube and ice level control stat mounting for units with top-mounted ice machines
Fig. 7 – Ice transport tube
ice level control stat
45°
Hand bend cap tube
end to approximately
45° as shown
.75"
(19mm)