14
110 Series Ice and Water Dispensers
User information
How the dispenser works
Follett’s 110 series automatic load ice and water dispensers receive ice from Follett’s 400 lb (181kg)/day ice machine
located in the dispenser base, in the cabinet top or in a remote location up to 20 ft (6m) away. Ice produced is stored in the
bin section of the dispenser. When dispensing is activated, the wheel motor is energized, causing the wheel to turn. This
moves ice to the dispense chute where it drops by gravity into the container held below the chute.
In Follett’s continuous icemaking process, water freezes to the inside walls of the stainless steel evaporator. A rotating
stainless steel auger carries the ice to the top of the evaporator where it is compressed and extruded through a nozzle on
the outlet port. The ice is then pushed through a tube to the dispenser bin. When the storage area is full, a bin thermostat
opens and shuts the ice machine off to avoid over-fi lling of the bin. The ice machine will restart after 20 minutes if the bin is
calling for ice.
How the SensorSAFE accessory works
Follett’s SensorSAFE accessory maximizes sanitation and minimizes the possibility of cross-contamination by eliminating
physical contact between the cup or container and dispenser. Sensors in the panel use refl ected infrared light to detect the
presence of the container and send a signal to a control board which then activates the appropriate components for ice or
water dispensing.
The SensorSAFE package includes a cleaning switch under the left side of the front cover which temporarily shuts off
dispensing to allow cleaning of the panel and lenses. If the switch is not turned back on after cleaning, the dispenser
automatically resets after two minutes for normal operation.
SensorSAFE also includes a time limit safety feature which automatically stops ice dispensing after one minute of
continuous dispensing. Dispensing can be resumed by moving the container away from the dispenser and returning it to
the activation zone.
How the chilled water accessory works
Follett’s chilled water accessory uses ice from the dispenser’s storage hopper to chill incoming water supplied to the water
station. The water chiller assembly is located in the dispenser cabinet under the storage hopper. As ice is dispensed, it is
automatically fed into the water chiller assembly to chill the water coil inside the assembly.
Cleaning/descaling and sanitizing
Periodic cleaning/descaling and sanitizing of Follett’s ice and water dispenser and ice machine system is required to
ensure peak performance and delivery of clean, sanitary ice. The recommended cleaning procedures that follow should
be performed at least as frequently as recommended and more often if environmental conditions dictate.
Cleaning of the condenser can usually be performed by facility personnel. Cleaning/descaling and sanitizing of the
ice machine system should be performed by your facility’s trained maintenance staff or a Follett authorized service
agent. Regardless of who performs the cleaning, it is the operator’s responsibility to see that this cleaning is performed
according to the schedule below. Service problems resulting from lack of preventive maintenance will not be covered
under the Follett warranty.
Recommended cleaning/descaling and sanitizing intervals*
Symphony
Frequency
Drain Line
weekly
Drain Pan/Drip Pan
weekly
Exterior
as needed
Condenser
monthly (air-cooled only)
Dispenser and Components
semi-annually
Ice Machine
semi-annually
Chilled Water Accessory
semi-annually
Transport Tube
semi-annually
Ice Storage Area/Bin
semi-annually
* Ice machine and dispenser must be cleaned and sanitized prior to start-up.
Содержание 110CR400A/W-L
Страница 2: ...2 110 Series Ice and Water Dispensers...
