6408 216th St. SW | Mountlake Terrace, WA 98043 | USA | Tel: +1 (425) 778.7728 | Fax: +1 (425) 778.7727
Introduction
User’s Guide:
RC-1 Remote Control
Introduction
The AirTools RC-1
is an accessory remote control for the
6200 Digital Voice Processor. The RC-1 provides limited control; it al-
lows the user to select and load the eleven user-selectable sequential
Programs of the 6200. The RC-1 also makes provision for selection
of a BYPASS function, which is Program 0 on the 6200. This bypass
function is the equivalent of the DSP Bypass function in the 6200. The
RC-1 may also be used with other MIDI controlled equipment to select
Programs 0 through 11.
Mechanical Data
ITEM
DESCRIPTION
DETAILS
Space Required
WDH: 17.9 cm x 9.56 cm x 3.68 cm / 7.05 in
x 3.75 in x 1.45 in. Depth does not include
connector allowance.
Allow at least 1 inch additional clearance for rear panel connections. Additional
depth may be required depending upon your specific wiring and connections.
Electrical
9 VDC / 30 mA.
Power comes from the 6200 via the included cable or user-supplied source.
Ventilation
Maximum recommended ambient operating
temperature is 30 C / 86 F.
Ventilation should not be impeded by covering the unit with items such as newspa-
pers, tablecloths, curtains, etc.
Weight
0.24 kg / 0.52 lbs.
FRONT PANEL
ITEM
DESCRIPTION
DETAILS
Labels (PROGRAM X)
12 x Screened labeling areas
Labeling areas are generically labeled “PROGRAM 1” through “PROGRAM 11” plus
“BYPASS (PROGRAM 0) which corresponds to the DSP BYPASS function of the 6200. User-
supplied stick-on labels can be used for custom labeling.
LEDs
12 x Green LEDs
Tally LEDs which light to indicate which program button was last pressed.
Buttons
12 x Momentary buttons
Momentary buttons which recall the associated program when pressed.
REAR PANEL
ITEM
DESCRIPTION
DETAILS
POWER INPUT
2.1 mm barrel jack
Accepts power from a user-supplied DC power source. (Not necessary when using with
a 6200).
MIDI OUT/POWER IN
Female 7-pin DIN
Sends MIDI Program Change messages out to the 6200 (or other MIDI device) and receives
DC power from the 6200.
