SYMEO Local Positioning Radar System
LPR®-1D24
LPR®-1D24 Station
– Overview and Mounting
General Information
Copyright © SYMEO GmbH 2015
LPR-1D24_Users_Manual_FCC-IC-Edition_EN.docx
Page 7 of 34
1.6
Setup and Operation
During mounting, make sure that no objects or liquids reach inside the
device (risk of short-circuit).
In case of emergency (e.g. damaged housing, control elements or power
cables, penetration of liquids or foreign bodies) switch off the device
immediately, disconnect from the power line the device and inform your
SYMEO service.
Protect the contacts of all sockets and plugs of the device from static
electricity. Avoid touching the contacts. If touching the contacts is
unavoidable, then one should take the following precautions: Touch a
grounded object or wear a ground strap before touching the contacts.
This will dissipate static charges.
The device must be secured against falling.
The LPR
®
-1D24 unit must not be opened.
1.7
System Extensions and Accessories
Data cables to peripheral devices must be shielded properly.
For LAN cabling, the requirements apply in accordance with EN 50173
and EN 50174-1/2. Use of either a Category 5 shielded cable for 10/100
Ethernet or Category 5e shielded cable for Gigabit Ethernet is a
minimum requirement. The specifications of standard ISO/IEC 11801
must be complied with.
The warranty becomes void in case of any damages caused by
replacement of components on the device during installation.
1.8
Additional Instructions
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
1.9
General Requirements for Compliance of Radio Apparatus
This device complies with Part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
