Symbol SPT 1700, Руководство по продукции

Страница: 36 / 317

1-14
SPT 1700 Series Product Reference Guide
Spare Battery Charging
The CRD1700-1000S single-slot cradle has a spare battery charging slot which charges the
terminal’s spare battery. Insert the battery in the spare battery charging slot in the back of the
cradle. The spare battery charging LED turns red to indicate the spare battery is charging,
then turns green after approximately two hours to indicate the battery is fully charged.
Starting the SPT 1700
After charging and installing the battery, start the terminal by pressing the red power button
on the front of the unit. If the terminal does not power on, perform a hard reset.
Note: When starting the terminal for the first time, or whenever the battery
is completely drained, a hard reset is required.
To hard-reset the terminal:
1. Remove the battery cover from the back of the terminal.
2. Hold down the power button on the front of the SPT 1700 terminal.
3. While holding down the power button, use the tip of the stylus to gently press the
reset button on the back of the terminal.
4. Release the reset button.
5. Release the power button.
6. When a message appears on the screen warning that you are about to erase all the
data stored on your SPT 1700 terminal, do one of the following:
a. Press the upper half of either of the scroll buttons on the front panel of the SPT
1700 terminal to complete the hard reset and display the Digitizer screen.
Spare Battery
Charging LED