Symbol PDT 8100 Series, Руководство по продукции

Страница: 289 / 402

12-17
Maintenance and Troubleshooting
CRD 8100-4200E
Table 12-5. Troubleshooting The CRD 8100-4200E
Symptom Cause Solution
Attempt by the terminal to
ActiveSync failed. Terminal removed from the
cradle while the LED was
blinking green. Wait one minute and reinsert
the terminal in the cradle. This
allows the cradle to attempt
another synchronization.
ActiveSync on the host
computer has not yet closed the
previous ActiveSync session. Wait one minute and reinsert
the terminal in the cradle. This
allows the cradle to attempt
another synchronization.
Incorrect cable configuration. Check your DHCP server and
determine which IP address
was allocated to the cradle, then
check connectivity by pinging
the cradle.
Communications software
improperly configured. Perform setup as described in
Communication Setup on page
4-6. Check your DHCP server
and determine which IP address
was allocated to the terminal
slot, then check connectivity by
pinging the cradle.
Terminal ActiveSync disabled or
not configured to accept
network connection. On the terminal, uncheck Start -
ActiveSync - Tools - Options -
PC - Enable synchronization
when cradled using:.
Host ActiveSync disabled or not
configured to accept network
connection. On the host computer, check
File - Connection Settings -
Allow network (Ethernet) Server
Connection with this desktop
computer.
During communications, no
data was transmitted, or
transmitted data was
incomplete. Terminal removed from cradle
during communications. Replace terminal in cradle and
retransmit.
Terminal has no active
connection. An icon will be visible in the
status bar if a connection is
currently active.