Symantec NORTON GHOST, Руководство пользователя

Страница: 63 / 80

Command-line switches
63
Sets the ASPI driver to report a read/write as successful only when the data
has been transferred to the physical medium. Useful when using older or
unreliable tape devices or sequential media.
-tapespeed=x
Allows control of tape speed. Where x equals 0 to F. 0 is default, 1-F
increases tape speed. Only use this when the tape does not work correctly
at the speed used by Norton Ghost.
-tapeunbuffered
Sets the ASPI driver to report a read/write as successful only when the data
has been transferred to the tape drive. (It is possible that this occurs before
the data is actually physically written to the medium.)
-vdw
If this switch is set, Norton Ghost will use the disk’s verify command to
check every sector on the disk before it is written. The action Norton Ghost
takes if a sector fails the verify depends on the -bfc switch.
-ver
Displays the version number of Norton Ghost.
-ver=value
Tests the version number of Norton Ghost. If the version number value
given is less than the version number of Norton Ghost, Norton Ghost will
operate normally. If the version number value given is greater than the
version number of Norton Ghost, Norton Ghost will abort and exit before
carrying out the command.
-wd-
Disables disk caching on destination disk.
-ws-
Disables disk caching on source disk.
-z
Compress when saving a disk or partition to an image file.