Sym Joyride S 125i, Руководство пользователя

Страница: 17 / 31

16
10.Inspection and Maintenance before Riding
【
Oil Filter Cleaning
】
Open the filter nut assembly of the element, and
remove the element. Remove the foreign materials
from the element by using gasoline and air compressor
dust removing gun.
WARNING:
•
Oil level will not be correct when checking the oil level with the scooter parked on an unleveled ground
or immediately after the engine stopped.
•
Engine and exhaust pipe are hot right after engine stopped. Pay special attention not to get burned
when checking or replacing engine oil.
FUEL INSPECTION
•
Turn main switch key to "ON" position, and check fuel gauge's needle range to make sure there is enough
amount of fuel in the fuel tank.
•
This scooter’s engine is designed for using the unleaded fuel of Octane 90 or above.
•
Firmly secure the main stand on the ground, shut off the engine and keep flames away from the scooter
when refueling.
•
Do not fill above fuel upper limit level when refueling.
•
Make sure the fuel tank cap had been tighten properly.
•
Ethanol in gasoline can not be more than 10%.
TRANSMISSION OIL INSPECTION AND CHANGE
INSPECTION:
•
Use the main stand to support the scooter on a level ground, after the engine stops, wait for 3~5 minutes.
Remove the transmission oil infusion bolt, put a measuring glass under the drain bolt, and remove the drain
bolt. Let the oil flows into measuring glass and check for decreased or not. (at disassembly: 110 cc. / at
change: 90~100 cc.).
OIL REPLACEMENT:
•
Stop the engine and use the main stand to support your scooter on a level ground. Remove the infusion
bolt and drain bolt, drain out the oil.
•
Install the drain bolt and tighten it. Fill new transmission oil (90~100 cc.), and install the infusion bolt and
tighten it. (make sure that bolts are tightened and check that there’s no leakage.)
※
Recommend Gear Oil:
SYM
Genuine “
SYMOIL” series Gear Oil (SAE10W-30/SAE85W-90).
INSPECTION AND ADJUSTMENT OF BRAKE FREE PLAY
INSPECTION:
(Brake lever free play must be checked with the engine shut off.)
•
Brake lever free play for front and rear wheels
When checking the hand-braking lever for front and rear wheels, its freeplay (the stroke of hand-braking
lever from no braking to initial braking) should be 20~30mm. It is abnormal if the feel is spongy when
holding the hand-braking lever forcefully.
20~30 mm