Sym Jet Sport X R50, Руководство по обслуживанию

Страница: 161 / 181

15. Electrical Equipment
15-4
Battery
Battery Removal/Installation
Turn off main switch.
Open seat, remove 2 screws and then open
battery cover.
Disconnect the negative cable terminal first, then
the positive cable terminal.
Remove the battery from the scooter.
Install the battery in reverse order of removal.
Voltage Check
Open seat and battery cover.
Remove wires from battery.
Check battery voltage.
Voltage:
Fully charged: 13.0~13.2V
Undercharged: 12 V
Charging
Remove the battery.
Connect the positive terminal (+) of the charger to
the battery positive terminal (+).
Connect the negative terminal (-) of the charger to
the battery negative terminal (-).
Standard charging current/time: 0.7A/5~10 hrs.
Fast charging current/hrs: 3A/1 hr.
Caution
Strictly keep flames and sparks away while
recharging to avoid to explosion causing by
hydrogen.
Stop charging battery when electrolyte
temperature is over 45
℃
(117
℉
).
Fast charging the battery is for in emergency
only. Battery should be charged in standard.
Current Leakage Inspection
Turn the main switch to OFF position, and remove
the negative cable terminal (-) from the battery.
Connect an ammeter between the negative cable
terminal and the battery negative terminal.
Caution
In the current leakage test, set the current
range at larger scale, then gradually
decrease to the lower scale as the test
process goes to avoid possible damage to
the ammeter and the fuse.
Do not turn the main switch to ON position
during test.
If the leaked current exceeds the specified value, it
may indicate a short circuit.
Allowable current leakage: Less than 1 mA
Disconnect each cable one by one and take
measurement of the current of each cable to
locate the short circuit.
Negative terminal
Positive terminal
This chapter Contents
Ammeter
Battery (-) terminal
Ground circuit