4. FUEL INJECTION SYSTEM
4-21
Error Code Message and Solution Operation
DTC
Code
Solution
Priority
Flash
code
Message Solution
Operation
P0217 1 1
Engine
temperature
overheat
1. Stopping the motorcycle immediately, and solve it
with priority
2. Check if the lubricant system for abnormal?
3. Is the ignition or fuel supply system in normal?
4. Has the engine shown burnt?
5. Make sure if the engine temperature senor is in
normal.
6. Make sure if the connector is in normal.
P0335 2 2
Crank position
sensor
1. Check if the connection of the crank position sensor
is open-circuit.
2. Check if the air gap between the sensor and gear
tooth is within specification.
3. Check if the crank rotation is run-out.
4. Check if the sensor is in normal according to the
new component replacement procedure.
P1120 2 3
Poor contact of
the throttle
valve sensor
1. Connect the disgnosisor and reset the throttle valve
position. Make sure if the idle speed position is
within specified range.
2. Make sure if the wire circuit of the throttle valve
position sensor is loosen or short.
3. Check if the openness of idle speed by-pass valve
is within specification. (40~100%)
4. Adjust the idle speed CO value to specified range.
(0.5%~2.0%)
5. If this problem symptom still existing, check if the
throttle position sensor (TPS) is in normal according
to the new component replacement procedure.
P1121 2 4
Application
malfunction of
the throttle
position sensor
1. Make sure if the wire circuit of the throttle valve
position sensor is loosen or short.
2. If this problem symptom still existing, check if the
throttle position sensor (TPS) is in normal according
to the new component replacement procedure.
P1122 2 5
Rotation speed
malfunction of
the throttle
position sensor
1. Make sure if the wire circuit of the throttle valve
position sensor is loosen or short.
2. If this problem symptom still existing, check if the
throttle position sensor (TPS) is in normal according
to the new component replacement procedure.
P0560 1 6
Abnormal
battery voltage
warning
1. Make sure if the battery voltage is too low or high
(below 10V or exceed 16V)
2. Make sure if the ACG generator charging system
circuit is short or abnormal.
3. Make sure if the 15
th
terminal on the ECU to battery
positive post is short.
4. Make sure if the battery is in normal. Replace it with
new if the battery is out or order.
P0110 2 7
Abnormal
intake
temperature
sensor
1. Make sure if the sensor’s resistor is in normal (20
℃
2353~2544
Ω
).
2. Make sure if the sensor’s wire is in open-circuit (the
22th terminal on ECU).
3. Make sure if the sensor is normal according to the
new component replacement procedure.
P0410 2 8
Abnormal air
by-pass valve
1. Make sure if the sensor’s resistor is open or short
circuit.
2. Make sure if the sensor’s wire is in open-circuit (the
13th terminal on ECU)
3. Make sure if the by-pass valve is normal according
to the new component replacement procedure.
