3. Lubrication System
3-7
Gear Oil
Oil Level Inspection
Park the motorcycle on flat surface with main
stand.
Turn off engine and remove both engine oil filling
bolt and oil draining plug.
Remove gear oil filling hole bolt and place a
measurement cup under the draining plug.
Remove the oil draining plug and the pour gear
oil into the measurement cup. Measure the
gear oil quantity if within standard value.
Add specified gear oil if the oil level too low.
(Standard quantity: 110cc. / replacement: 100
cc.)
Gear Oil Replacement
Remove the gear oil filling hole bolt and its
draining plug and then drain oil completely.
Install the draining plug and tighten it (Make sure
if the plug washer is damaged. If so, replace it
with new one.)
Torque Value: 0.8~1.2 kgf-m
Add new gear oil (100 c.c.) from the gear oil
filling hole and then install the gear oil filling hole
bolt after added oil. And then, tighten the bolt.
Torque Value: 1.0~1.4 kgf-m
※
Recommended to apply with SYM HYPOID
GEAR OIL (SAE 85W-140)
Start engine and run it for 2~3 minutes.
Turn of f engine and check if oil leaking.
Draining plug
Filling bolt
