4
Step 11: Carefully move the assembled unit to the desired location. The Fireplace Man-
tel should not be positioned in an area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE is highly recommended in order to reduce
the risk of the fireplace being tipped over accidentally. WARNING: This CABLE may re-
duce possible risk of injury if the fireplace is improperly handled, but is not a substitute
for proper adult supervision. Children should not be left unattended near any heater.
1. Drill a 5/16” (8mm) hole in the wall. Insert the PLASTIC WALL ANCHOR into the
hole and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantle close to the wall.
3. Attach the SAFETY CABLE to the mantle using the SCREW FOR MANTEL.
4. Use the SCREW FOR WALL to attach the other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
WALL
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace in-
sert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
ON/OFF:
Press this button for main power and flame effect. The indicator light will
turn on. See below for other control switches.
750W:
For low heat function - Press this switch while the ON/OFF switch is in the on
position for low heat. The indicator light will turn on.
1500W:
For high heat function - Press this switch while the ON/OFF switch and the
750W switch are in the on position for high heat. The indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired tem-
perature and to the left for lower temperature. This temperature control dial can only
be used while the ON/OFF switch and 750W & 1500W switches are in the ON position.
When the heater reaches the desired temperature, the heater and 750W/1500W
indicator light will turn off but the fan will continue to operate. Adjust this knob to
restart the heater.
Dimmer Control Knob:
Turn the dimmer dial clockwise or counter clockwise to get
the desired flame intensity. The dimmer switch can only be used when the ON/OFF
switch is in the on position.
Note:
When the ON/OFF switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
Note:
In order to shut down the heater safely, it is recommended to turn the Tempera-
ture Control knob to lowest setting and allow the heater to cool down before pressing
the ON/OFF switch to off position.
MAINTENANCE
maiNtENaNcE WarNiNG:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off the
unit and removing the light bulbs to avoid the accidental burning of the skin.
riSK OF FirE: DO NOt ExcEED tHE rEcOmmENDED BUlB WattaGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 3 screws on the back of fireplace and open the rear cover.
Step 2: You will find 2 X 40W Type B-10 bulbs under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover and secure with the 3 screws.
Step 5: Plug in the unit.