Sylvan SL41E, Руководство по установке

Страница: 8 / 20

8 www.sylvan.co.nz
1. Mark and crop door using installation template provided
2. Ensure holes are clear of any sharp edges and clean of
swarf and wood dust.
3. Adjust tongue of latch depending on the way the
door operates (refer to page 6)
Installation:
Step 1: Install Mortice (see mortice lock instructions included)
Step 2:
Install Outside
Lock Panel
1. Fit spindle to outside panel
with the correct length of
spindle for the door thickness
IMPORTANT
Ensure the split pin is fitted
through the follower and
spindle and the end is bent
around to prevent it working
out later. Ensure indicator is
always pointing down.
2. Install rubber boots (outside
and inside unit), ensuring
they fit correctly into each the
receiving holes in the back
face of the panel. NOTE these
only fit one way correctly.
3. Feed lock through the door
aligning spindle and posts
through lock and predrilled
holes in the door.
•
IMPORTANT
Feed power cable through
door to ensure adequate space
to accept excess cable in the
door to prevent the cable from
being crushed, damaged or
cut during the installation.

IMPORTANT
Ensure the indicator
on the follower of
the lock is pointing
down

IMPORTANT
Install T slot screw into the top slot, adjust to the
correct position to align up with holes in the door.
Attach connection posts to T slot screw and M5
screw at bottom of lock. Tighten with spanner.