• These should be recorded in a list together with other data
(employee name, access via fingerprint or transponder).
• Of the 1000 available user IDs, some are reserved for special
functions: e.g.
The master fingerprint for adding and
deleting user fingerprints or user transponders.
• One fingerprint and one transponder can be assigned to each
user ID.
• Any standard EM transponder which works with a transponder
frequency of 125 kHz can be used as a transponder.
b) Entering/exiting programming mode
To enter programming mode, you need to enter the master code
using the IR remote control. By default (default factory settings or
after a reset), the master code is "123456".
In the following programming examples, "123456" is
used as a master code (default setting).
Change the master code as soon as possible – no later
than when you have finished the programming steps.
Entering programming mode:
• The LED indicator (2) on the top of the code lock must be red.
The code lock is now in standby mode.
• Press the key. Once the code lock has detected the IR
signal from the remote control, the LED indicator on the code
lock will flash red (the code lock will automatically return to
standby mode after 5 seconds without any further input (LED
indicator (2) turns red).
23
