Swyx SX2 QuadBRI, Быстрый старт

Страница: 8 / 9

Q U I C K S T A R T
SX2 DualPRI V2
8
SX2 QuadBRI / SX2-express QuadBRI
LED Status Display
Each BRI connection is assigned one of the four LEDs. The number of the connection
corresponds to the number of the LED.
The following illustration shows a slot of the SX2 QuadBRI to identify the Basic Rate
Interfaces 1 to 4, shown here as L(ine) 1 to 4:
Figure 12 Lines of the SX2 QuadBRI
The following assignments are valid:
After the hardware for the SX2 QuadBRI has been configured according to the use scenario,
insert it into the PC on which SwyxGate is to be installed.
After the card has been installed physically, it will automatically be recognized the next time
the computer is booted and a request for the installation of the driver software will appear.
You may find more recent drivers for the ISDN cards in the download area of the homepage:
http://www.swyx.com/support/index.html .
Insertion of the ISDN Card
Do the necessary hardware configuration before the insertion. For more details, please read
chapter •, Preparation of the SX2 QuadBRI before insertion.
It is absolutely necessary that you turn off the PC and remove the mains plug from the
power supply whenever you are doing something which requires you to open the PC case!
Do not touch any of the electronic components of the PC card during the entire installation
process. The electronic components of the PC card can be damaged by electrostatic
discharges!
For safety reasons, it is necessary that you disconnect all connection cables from the
telephone network before you open the PC case.
LED Statement
off Layer 1 deactivated
red glowing Layer 1 activated
green glowing Layer 2 activated
green, blinking At least one connection is active
red, blinking The line is being configured
This is how you install the ISDN cards in your PC
1. Turn off your PC and pull the respective mains plug out of the socket.
2. Open your PC.
3. Remove the screw from the metal panel covering a free PCI (expansion) slot:
Figure 13 Removing the Metal Panel
4. Insert the ISDN PC card into a free PCI / PCI-X or PCI-express plug-in slot.
5. Use the screw you just removed to secure the PC card.
6. Connect the SX2 QuadBRI to the BRI ISDN connections using the cable which has
been supplied.
Figure 14 Connecting the ISDN Cable
7. Close your PC and restore the power supply by plugging in the mains plug.
Metal Panel
Expansion Slot
ISA
16-bit Expansion Slot
Case
Back
PCI / PCI-X
PCI express-
Slot