Q U I C K S T A R T
SX2 DualPRI V2
4
SX2 QuadBRI / SX2-express QuadBRI
Configuration of the BRI Bus Terminal
•
In TE mode, the termination depends on the cabling.
•
In NT mode the termination should be switched on, since the card then normally
represents the end of the BRI bus.
Next to the block of jumpers for a connection, you will find a two-pole DIP switch which
can be used to configure the BRI bus terminal.
Figure 5 Configuration of the BRI Bus Terminal of SX2 QuadBRI
PCI Plug Strip
ISDN connections
DIP switches 1-4
Figure 6 Configuration of the BRI Bus Terminal of SX2-express QuadBRI
If both pins of the switch are in the "ON" position, the 100 ohm terminal is switched on,
otherwise it is switched off.
Both pins must have the same setting.
PCI-express plug strip
ISDN connections
DIP switches 1-4
