Q U I C K S T A R T
SX2 DualPRI V2
1
SX2-express SinglePRI / SX2-express DualPRI
•
Properties ofSX2-express SinglePRI / SX2-express DualPRI
ISDN Interface
•
SX2-express SinglePRI: 1 x PRI interface or SX2-express DualPRI: 2 x PRI interface
•
Each line can be configured individually using a jumper field for the TE or NT mode.
•
Failover Relay on the SX2 DualPRI. This enables the two lines to be directly connected
to each other in the event of power failure or software problems, so that a PRI external
line can be looped through the card. This can be used for standby scenarios.
•
A maximum of 4 different cards (SX2 QuadBRI, SX2 SinglePRIand SX2 DualPRI) can
be used in one PC. In doing so, a maximum of 76 B channels will be supported.
PCM Highway
•
Tact synchronization only between the different SX2-express cards is possible. The
cards are connected with a ribbon cable.
•
2/4/8 Mbit/s data transfer rate
•
Chipset: Exar XRT86VL
•
6 DIP Switches
•
Exact 32,768 MHz quartz oscillator
•
PCIe x1 Interface
General purpose I/O
•
Four LEDs (red/green) on the mounting bracket of the ISDN card per PRI interface
•
Four DIP switches per PRI interface that can be used for the identification of the card
•
You will find more recent drivers for the SX2 in the download area of the homepage:
http://www.swyx.com/support/index.html
•
Installation of the ISDN PC Cards
The ISDN card can be installed in the same PC on which the SwyxServer is also installed. In
the standard installation, the SwyxGate service is also installed. This service controls the
ISDN lines that appear in the SwyxWare Administration as an ISDN trunk.
In order to be able to install a SwyxGate on a separate PC, the SwyxServer must already be
installed and operable. For the SwyxGate installation you will need
•
the server name and
•
the name of the domain account, which was created in preparation for the installation of
the SwyxServer
Before the ISDN cards are inserted, they must be configured for operation.
Mixed operation of different SX2 cards isn't possible!
