300143 RevA
Page 3 of 9
Permanent Mounting
1. Determine the location of the lightbar, and the best route for the wiring. (see Wiring Instructions section)
2. Determine the position of the mounting feet and drill the 5/16”-11/32” diameter mounting holes accordingly, if needed. The spacing
of the mounting feet from left to right is adjustable. It is suggested that the positioning of the feet be symmetrical and near the curved
edges of the roof where the roof is strongest. Ideally, the outermost holes on the feet should be used for installation.
3. Mount the lightbar, with the bolts going through the holes drilled in step 2, routing the wire as planned in step 1. Install washers and nuts
and secure the unit. The use of thread locking compound is recommended.
VEHICLE ROOF
(CUT OUT)
LIGHTBAR
LOAD WASHER
5/16” NYLOCK NUT
5/16” COACH BOLT
7.86”
5.31”
CARRIAGE
BOLT
