300143 RevA
Page 2 of 9
WARNING!
Failure to install or use this product according to manufacturer’s recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
!
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the use, care and maintenance of emergency warning devices are essential to
ensure the safety of emergency personnel and the public.
2. Eme
rgency warning devices often require high electrical voltages and/or currents. Exercise caution when working with live electrical
connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arc-
ing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation is vital to the performance of this warning device. Install this product so that output performance
of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system
without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure daily that all features of this product work correctly. In use, the vehicle opera-
tor should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks or compartment doors),
people, vehicles or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to an emergency warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection,
drive against traffic, respond at a high rate of speed, or walk on or around traffic lanes.
7. Th
is equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws
regarding emergency warning devices. Therefore, the user should check all applicable city, state, and federal laws and regulations.
The manufacturer assumes no liability for any loss resulting from the use of this warning device.
8. This product may contain high intensity LEDs. Staring directly into these lights could result in temporary and/or permanent vision
impairment.
Installation & Mounting:
Mounting
Before proceeding with installation, plan all wiring and cable
routing. Select the mounting location for the lightbar on a
flat, smooth surface and center the unit across the width of
the vehicle. The mounting location for the lightbar should
be chosen such that the lightbar is level and visibility to
approaching traffic is optimized. Mounting should be such that
there is no less than ½” clearance between the roof and the
lightbar at any point.
Caution:
When drilling into any vehicle surface, make sure that the area
is free from any electrical wires, fuel lines, vehicle upholstery,
vehicle support members, etc. that could be damaged.
!
Specifications:
Length.................48”,54”,60”
Height..................2.5” Width: 11”
Voltage................12-24VDC
Current Draw.......LED Module = 0.45A Avg. @ 12.8VDC
LED STT(pair) = 0.25A Avg.@ 12.8VDC
LED AL,TD,WL (pair) = 1.80A Avg. @ 12.8VDC
Flash Patterns.....24 (See chart)
Flash Pattern Chart
#
Flash Pattern
FPM
SAE
LEVEL
YELLOW
CA T13
YELLOW
1
Steady
N/A
2
Quad
120
CLASS 1
NO
3
Double
75
CLASS 1
NO
4
Slow Quad
65
CLASS 1
YES
5
Slow Double
65
CLASS 1
YES
6
Quint-Hold
70
CLASS 1
NO
7
Pulse8
70
CLASS 1
NO
8
Quad, Alternate Side-to-Side
150
CLASS 1
NO
9
Quad, Cross Alternate
150 CLASS 1S
NO
10
Double, Alternate Side-to-Side
150
CLASS 1
NO
11
Double, Cross Alternate
150 CLASS 1S
NO
12
Quint-Hold, Alternate Side-to-Side
150
CLASS 1
NO
13
Quint-Hold, Cross Alternate
150 CLASS 1S
NO
14
Fast Rotate
N/A
NO
15
Rotate/Quad
N/A
NO
16
Wave Rotate
N/A
NO
17
Quad, Alternate Side-to-Side, Front
150 CLASS 2S
NO
18
Quad, Alternate Side-to-Side, Rear
150 CLASS 2S
NO
19
Double, Alternate Side-to-Side, Front
150 CLASS 2S
NO
20
Double, Alternate Side-to-Side, Rear
150 CLASS 2S
NO
21
Quint-Hold, Alternate Side-to-Side, Front
150 CLASS 2S
NO
22
Quint-Hold, Alternate Side-to-Side, Rear
150 CLASS 2S
NO
23
Quad, Alternate Side-to-Side, Middle
150 CLASS 1S
NO
24
Cycle All
N/A
NO
