STEALTH DIGI-CUT 100 CNC
9
4 OPERATION CONTROL AND CONNECTORS
1.
Cutting current regulator – used to regulate the current when cutting.
2.
Power pilot lamp
3.
Over-current / Over-heat alarm – when over-heat or over-current, the lamp would is lit.
4.
Current display
5.
Cutting gun incorrect installation and air pressure low alarm
6.
Barometer display
7.
Work lamp – turn on the switch of the cutting gun, generate the voltage, the lamp on
8. RUN/SET – when cutting the workpiece, turn to ‘RUN’. When performing a gas test,
turn to ‘SET’.
9.
Cutting gun connector – connect to the cutting machine.
10. Remote control plug
11. Positive output cable – connect to the workpiece.
12. Barometer – ensure there is no impurity and moisture in the compressed air.
13. Power cable – connect to the appropriate power supply.
14. Power switch – turn on or off the power source.
7
§4 Operation
4.1 Layout Of The Front And Rear Panel:
Fig 4.1 schematic drawing of the front panel and rear panel
1.Cutting current regulator:
it is used to regulate the current when cutting.
2. Power pilot lamp
3. Over-current ,over-heat alarm :
when over-heat, over-current, the lamp would be on.
4.Current display
5.Cutting gun improper installation and air pressure low alarm
6.Barometer display
7. Work lamp:
turn on the switch of the cutting gun, generate the voltage, the lamp on
8. RUN/SET:
when cutting the workpiece, turn to the “RUN”; when doing gas test, turn to the “SET”.
9.Cutting gun connector:
connected to the cutting machine
10.remote control plug
11.Positive output cable:
connected to the workpiece
12.Barometer :
ensure there are no impurity and moisture in the compressed air
13.Power cable:
connected to the appreciate power supply
14.Power switch:
turn on or off the power source
