INSTALLING YOUR FAN
Drive a wood screw and washers into the side of the
brace that holds the outlet box.
Insert the safety cable through the hanger bracket
and also insert one of the holes in the outlet box
into the ceiling. Adjust the length of the safety cable
to reach the screw and washers by pulling the extra
cable through the cable clamp until the overall
length is correct, put the end of the cable back
through the cable clamp, forming a loop at the end
of the cable.
Tighten the cable clamp securely. Now, put the loop
in the end of the safety cable over the wood screw
and under the washer. Tighten the wood screw
securely.
06
Release 1 screw of the hanger bracket socket.
Place the downrod ball into the hanger bracket
socket. Make sure the hanger ball is seated in the
groove on the hanger bracket.
Rotate fan until notch on downrod ball engages the
ridge on the mounting bracket.
After hanging fan onto the mounting bracket, make
sure plug connectors from the ceiling fan and
terminal block away from the space located above
the downrod ball. Slide the remote receiver into the
space above the downrod ball as shown.
STEP.
09
Fig.9
STEP.
10
Fig.10
Black
Grounded/Green
White
Grounded/Green
RED
GREY
YELLOW
OK
NO
