Restore power to ceiling fan and test for proper operation.
AFTER INSTALLATION
1
ON/OFF THE FAN
Turn up the speed of the fan
Turn down the speed of the fan
3V CR2032 battery X 1pc
Direction of the fan (reverse switch)
Short press: ON/OFF the light
Long press: Adjust the brightness of the light
Press this button to switch the light colors
when the light is on
The fan and light will turn off after 1 hour
The fan and light will turn off after 3 hours
The fan and light will turn off after 6 hours
1
2
3
4
10
5
6
7
8
9
2
3
4
5
9
10
8
6
7
“WOBBLE”
The fan blades have been adjusted in the factory to minimize any wobble
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE MOUNTED
ON A RUBBER CROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING, IT WOULD CAUSE
EXCESS VIBRATION. MOVEMENT OF A FEW CENTIMENTERS IS QUITE ACCEPTABLE AND DOES NOT
SUGGEST ANY PROBLEM
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH SECURED THE MOUNTING
BRACKET AND DOWNROD ARE SECURE.
BALANCING A WOBBLING CEILING FAN:
For your convenience, a Balancing Kit is included; please follow this procedure when balancing the fan:
Check that all blade and blade arm screws are secure.
Most fan wobbling problems are caused when blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip of one of the blades. Measure this distance. Rotate
the fan until the next blade is positioned for same measurement. Repeat for each blade. The
distance deviation should be equal within 1/8"(0.32cm).
1
2
10
Touching
Ceiling
3V
+
CR2032
