Swisson XND-4, Руководство пользователя

Страница: 12 / 18

12
Confirm your selection by pressing [OK].
Repeat the above steps for the remaining characters. Then, press [Cancel] to finish inserting characters.
Press [Cancel] again to quit the editor.
Press [OK] to store the changes or press [Cancel] to discard all changes.
Short Name
The short name can be viewed and edited under Home > Menu > Art-Net > Short Name. Editing the short name is
done in the same way the name is edited.
Output Settings and Information
For each output port, there is an output port settings menu under Home > Menu > Outputs >
Output [1-4]. E.g. the menu for output 1 is under Home > Menu > Outputs > Output 1. The
output settings menu contains the items described below.
Enable/Disable
Under Enable/Disable, a selection list is presented to you with the following options:

Enable: The port is enabled.

Disable: The port is turned off.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] in order to apply the setting.
Merge Mode
Under Merge Mode, a selection list is presented to you with the following options:

HTP: Highest takes precedence. If for a given DMX channel data has been received from two sources, the
higher value is used.

LTP: Latest takes precedence. If for a given DMX channel data has been received from two sources, LTP
merging uses the value of whichever source was the last to change the value it has sent for that given
channel.
Merging is applied when more than one Art-Net controller sends data for the same port. If more than two
controllers send data for the same port, only two controllers are taken into account.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK], in order to apply the setting.