52
Appendix
Gigaset CX100-150isdn / englisch / A31008-X150-G101-1-7619 / appendix.fm / 20.01.2004
Appendix
Care
Wipe the base and the handset with a
damp
cloth (do not use any solvent) or an
antistatic cloth.
Never
use a dry cloth as this can cause static discharge!
Contact with liquid
If the handset should come into contact with liquid,
on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and Answers
If you have any questions about the use of your phone, you can contact us at any time
of the day and week at
www.my-siemens.com
/customercare. You will find the most
frequently asked questions and answers below.
!
What has happened
when …
Possible Cause
Possible solution
… the display is blank?
The handset is not switched on.
The batteries are flat.
Press the end call key
a
for
around 2 sec.
.
Charge or replace the batteries
(page 8).
… the handset fails to respond
to a key press?
The keypad lock is activated.
Press the hash key
R
for
around 2 seconds
to
deactivate the lock (page 9).
…
Base 1
or
Searching for
Base
, for example, is flashing
on the screen?
The handset is outside the range
of the base.
The handset is not registered.
The base is not switched on.
Move the handset nearer to the
base.
Register the handset
(page 41).
Check the power connector at
the base (page 6).
… the handset does not ring? The ringer is switched off.
Activate the handset ringer
(page 46).
… the incoming call number is
not displayed even though
CLIP is set?
Calling Line Identification is
blocked.
The caller must ask his network
provider to enable the
identification of his number
(CLI).
… the handset does not ring
after the ISDN number (MSN)
has been set up?
The area prefix has been stored
with the MSN.
Store MSN
without
area prefix
(page 33).
… there are
no incoming
calls
?
Call forwarding
Immediately
has been activated.
The MSN has not been assigned
to the internal user.
Deactivate call forwarding
Immediately
(page 37).
Determine the receive MSN
(page 35).
