Swisscom Aton CL200, Руководство по эксплуатации

Страница: 32 / 56

R We recommend turning the base unit ringer
off (page 28) in addition to turning the night
mode on. (Aton CLT200 series: page 3)
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1
(middle soft key) #238
2
MbN : Select the desired setting. a
R If you select “ Aus ” , press M N to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
a
R You can select 24-hour or 12-hour
clock format (
“
AM
” or “
PM
” ) by
pressing .
4
Enter the desired hour and minute you
wish to end this feature.
a
5
M N
R When the night mode is set, is
displayed.
Changing the start and end time
1
(middle soft key) #237
2
Continue from step 3, “Turning night
mode on/off”, page 32.
Setting the ring delay
This setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select
“ Kein
Rufsign. ” , the handset never rings during
night mode.
1
(middle soft key) #239
2
MbN : Select the desired setting. a
a M N
Note:
R When the answering system answers the
call, this feature does not work.
(Aton CLT200 series: page 3)
Selecting categories to bypass night
mode
1
(middle soft key) #241
2
Select your desired categories by
pressing
1 to 9 .
R “ ” is displayed next to the selected
category numbers.
R To cancel a selected category, press
the same dial key again. “ ”
disappears.
3
a M N
Changing the handset name
Each handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is
“
Nein
” . If you
select “
Ja
” without entering any handset
name, “ Mobilteil 1 ” to “ Mobilteil 6 ”
is displayed.
1
(middle soft key) #104
2
Enter the desired name (max. 10
characters; page 46).
R If not required, go to step 3.
3
4
MbN : Select the desired setting. a 2
times
5
M N
Incoming call barring
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit sends out a busy tone to the
caller, and then disconnects the call.
Important:
R When the unit receives a call from a
number that is stored in the call barred list,
the call is logged in the caller list
32
Programming
ATON_CL200_CLT200(en-de)_0731_ve32 32 2014/07/31 20:28:34