![Swisscom Fixnet Classic S128 Скачать руководство пользователя страница 37](http://html1.mh-extra.com/html/swisscom-fixnet/classic-s128/classic-s128_manual_1415100037.webp)
36
Appendix
Gigaset C340 / SWZ-engl NUR für INTERNET / xxxxxxxxxxx / appendix.fm / 17.5.05
Appendix
Care
¤
Wipe the base and the handset with a
damp
cloth (do not use solvent) or an
antistatic cloth.
Never
use a dry cloth as this can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch the handset off and remove
the batteries immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place
for at least 72 hours
(
not
in a microwave, oven etc.).
4.
Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
Faults and Self-help with
Troubleshooting
Not every fault is due to a defective
phone. In certain circumstances, it can
come from a brief interruption in the
power supply to the base station (unplug/
plug in power supply) or if the batteries of
the handset are removed and inserted
again. The following instructions should
be of help for specific faults.
Important: problems or faults can only be
remedied if you bring the complete unit
(base station, handset, as well as connect-
ing cable) to the place of purchase.
!
The display is blank.
1. The handset is not switched on.
¥
Press the 'end call' key
a
and hold
.
2. The battery is flat.
¥
Charge the battery or replace it
The handset does not respond to a key
press.
The keypad lock is activated.
¥
Press the hash key
#
long
"Base x“
flashes
in the display.
1. The handset is outside the range of the
base.
¥
Move the handset closer to the base.
2. The handset has been de-registered.
¥
Register the handset (page 27).
3. The base is not switched on.
¥
Check the base's mains adapter
" Please Register" flashes in the display.
No base is switched on or within range.
¥
Move the handset closer to the base.
¥
Check the base's mains adapter (page 5).
Handset does not ring.
1. The ringer is switched off.
¥
Activate the ringer (page 33).
2. Call diversion is set to
¥
Switch off call diversion (page 12).