Swiss Timing OSV-STAR, Руководство пользователя

Страница: 10 / 29

Page 4 3434.505.02 Version 2.0
2 INSTALLATION
2.1 First setup
If you have ordered the optional internal battery [3434.980], you have to mount it in the camera
before the first use:
1. With the delivered tool, remove the screw that block the
battery cover (point 33 of chapter 1.1.4 ) and open battery
cover.
2. Inside the camera, find the cable with the connector
corresponding to the battery pack, and pull it (gently) a
little bit out of the camera.
3. Enter the battery pack in the location (with the wires on
the external).
4. Connect the connectors together and then insert totally
the battery.
5. Close the battery cover and block it with the screw
removed on point 1 using the delivered tool.
Remarks :

The battery is delivered uncharged.

Use only the delivered battery. Use of other kind of battery can seriously
damage the camera due to the charger type; in this case the camera
guarantee will be loosed.
2.2 Installation of the camera
The photofinish camera must be installed exactly on a virtual extension of the finish
line and the sensor must be vertically perpendicular to this line.
The inclination of the camera is important for the ease of judgment. In general, a vertical inclination
of 8
o
to 10
o
is used for the rowing and the canoeing, and of 10
o
to 20
o
(in relation to the middle of
the finish line) for the cycling, the horse-racings and of greyhound. For athletics, an angle of 25
o
to
30
o
is recommended in relation to the farthest lane in order to prevent the competitors in the
foreground masking another.

Centre the tripod on the extension of the finish line. If it is equipped with a spirit level, align
the bubble precisely in the middle of the reference mark. Then slowly tighten all screws
checking bubble does not move. For a better stability, spread the legs as far apart as
possible and do not raise the central extension tube: