Swiss Timing OSV-STAR, Руководство пользователя

Страница: 14 / 29

Page 8 3434.505.02 Version 2.0
2.7 Wiring the installation
Connect the delivered Start-Finish cable (3434.620) at the rear of the camera on the
START/FINISH connector (
29 ). Connect the start transducer on the TUCHEL Start plug of this
cable and the finish cell on the FINISH bananas of this cable. If you want to do manual recording of
images, it is recommended to connect a pushbutton (option 2872.003) on the FINISH bananas.
Connect the network cable Ethernet Gigabit (9051.1315) between the ETHERNET connector on
the camera (
25 ) and the computer.
If the GPS option is present and will be used, connect the antenna on the GPS
connector on the back of the camera (see also point 27 of chapter 1.1.3 ).

Push the plug of the cable until it clicks into place to connect the antenna.

Pull the plug of the antenna cable by the front part (F) to disconnect the
antenna.
Connect the provided AC/DC power adapter to mains power and the POWER connector on the
camera (
24 ). The camera will automatically start up (see chapter 2.8 ).
An external battery 12VDC can be used instead the AC/DC power adaptor when no mains power
is available at the site of the camera (option battery cable 3330.618).
2.8 Power on and power off
When the power cable is plugged, the camera starts itself. The green LED on the rear face should
be lit. The green LED of the AC/DC adaptor should also be lit.
At power on, the camera initializes itself during about 80 seconds, then, at least one of the two
yellow LED (vertical indicators) blinks; the camera can now be aligned and is ready for use.
To power off the camera, it is necessary to first exit the Scan'O'Vision
software on the
computer, and then remove the power cable.
When you power off the camera, the synchronization is lost.
With the optional internal battery, if the power is removed while the software is running, the internal
battery will automatically keep the camera on until the reserve power is depleted or you exit the
OSV-STAR software (in this case a question is asked if one wants or no to switch off the camera
from the software).
2.9 Loading of the internal battery
As soon as the camera is powered on (green LED lit), the optional internal battery starts charging if
necessary. It takes up to 9 hours to completely charge the internal battery.