Swisher Versa-RC, Руководство пользователя

Страница: 14 / 30

콆
߾
ʂ ذ
SERVICE & ADJUSTMENTS
PTO Shaft
Before every use, check to make sure the PTO shaft is
securely attached to both the tractor and attachment
gearboxes.
Before every use, check the PTO shaft u-joints to make
sure they are not damaged or worn. Simply lift up and
down on the shaft when it is securely connected to both
pieces of equipment. If there is excessive movement
then the PTO shaft may need to be replaced.
If there is excessive vibration during operation,
disengage the PTO switch, set the brake, stop the
engine, remove the ignition key and disconnect the
spark plug wire(s) and immediately inspect the PTO
shaft. Refer to Troubleshooting section.
It is recommended to grease all PTO Shaft joints every
8 hours (50 hours for extended intervals).
Lubricate all fittings with a good quality lithium soap
compatible EP grease meeting the N.L.G.I. #2
specification and containing no more than 1%
Molybdenum Disulfide.
An EP grease meeting the N.L.G.I. #2 specification and
containing 3% Molybdenum Disulfide may be
substituted in the telescoping members only.
14 14
2
2
1 3
1. Telescoping Shaft Grease Point
2. U-Joint Grease Point(s)
3. Sliding Locking Collar
Gearbox
The gearboxes are lubricated and sealed components.
If used and maintained properly, these gearboxes do
not require lubrication changes.
If there are internal component failures within the
gearbox, it is recommended to replace the entire
gearbox.
However, if the failed internal components are serviced
and/or replaced then new lubrication is required.
This gearbox requires 4 oz. of Bentonite grease. A
recommended brand is Brooks Benalene 900-P-RP.
Mower Blades
Sharpening and Replacement
WEAR HEAVY GLOVES
The blade disc assembly can be removed from the
keyed spindle shaft by removing the center ½” bolt,
washer and ¼” key.
Alternatively the blade disc assembly can be left on the
spindle and the individual blades can be removed by
removing the ¾” bolts from the top side of the disc that
hold the blade nuts.
The blades should be professionally sharpened equally
in sets to maintain balance.
The blades are bi-directional and can be turned over to
the unused side between sharpening.
Reinstall the bolts and washers in the reverse order
they were removed or refer to page 20 for assembly
order.
If the entire blade disc assembly was removed it is
recommended to use a thread locking compound on the
center ½” bolt during reassembly.