11
FB 430 / FB 450 / FB 500 / FB 510
1
2
3
4 5
FB 500 / FB 510
3
4
5
1
2
D
ok
: 101498D
-GB 2103
Main power switch
FB 510 instrument panel with;
1. Control lamps for the engine, charging, oil pressure and
hydraulic oil temperature
2. Starter key
3. Full throttle position
4. Stop mode
5. Throttle
Vibration power switch and
handle heating
Hatz decompression handle
BEFORE STARTING
See Daily Checks on page 8.
STARTING only FB510
Note! The vibration power switch on the handle must be in
the position “vibration off” (red/green marking). Other
-
wise the machine cannot be started.
Switch the throttle lever (5) to the full RPM position (3).
Insert the starter key (2) in position 0 and turn to the position
1 and check that the charging and oil pressure lamps (1) light
up. With the starter key in this position 1 the buzzer starts to
sound. Turn the starter key to the position 2. Release the key
as soon as the engine starts. It returns to position 1 and will
remain in that position during operation. Charging and oil
pressure light goes off immediately after the start. Engine light
(1) lights green while the engine is running.
Note! Never run the starter motor for longer than 10 seconds
at a time. If the engine does not start, wait 15 seconds before
trying to start it again.
In very cold weather or if the battery capacity is low for
a different reason, starting can be facilitated using the
decompression handle in connection with the valve housing.
Press the lever down and hold it down until the flywheel has
reached its maximum RPM. Run the engine warm for around
5 minutes.
STOPPING FB510
Turn off the vibration. Switch the throttle lever (5) to idle
and let the engine run for a few minutes.
Turn the starter key to the position 0.
Stop the engine by moving the throttle lever to the stop
position (4)
STOPPING FB500
Turn the starter key to the position 0.
Stop the engine by moving the throttle lever to the stop
position (4)
FB 500 Instrument panel
