swepac F 50B, Руководство пользователя в оригинале

Страница: 9 / 16

9
F 50B
1
3
2
D
oc: 101518-
GB 1838
V-belt drive
Check the tension and condition of the tyre regularly.
Replace damaged V-belt for new type XPZ662 for F 50.
NOTE: When replacing a V-belt, remove the protective cover.
Loosen the six screws holding the cover against the motor
plate. Divide the starter button cable before removing the cover
completely.
Adjustment of belt tension
Release engine screws (1, 4 pcs)
Tighten the strap by pulling the battery pack handle (3).
Tighten the screws.
Rubber dampers
Regularly check the rubber dampers’ (2, 4 pcs) condition.
Replace damaged dampers.
Polyurethane mat
During stonemasonry, a polyurethane mat is used to
protect stones and clinker
START
Start the machine by pressing the start button in position 1.
NOTE: The vibrations start straight away. Make sure
there is always free space around the machine during
the start-up.
STOP
Stop the machine by pressing the 0 button.
The machine may vibrate irregularly for a short period of
time during this phase.
From
To
DRIVING DIRECTIONS
The vibrating element of the machine is started with the start
button. Best packing is achieved at full turn on the engine.
Avoid driving the engine at other speeds, as it may cause
abnormal wear.
Due to its compact size and low weight, the machine is very
easy to operate. The bottom plate design allows you to pull
the machine back without destroying the packed surface. The
vibrating element of the machine will stop when the throttle
switch is set to idling.
The machine is intended for indoor and outdoor use. Work
with the machine in daylight or other adequate lighting. The
filling masses should be watered or naturally moist. All other
uses are advised against.
NOTE: When the battery starts to discharge, the packing
capacity is reduced.