SWELLPRO Spry+, Руководство пользователя

Страница: 24 / 38

©2019 SwellPro All Rights Reserved
24
Description Illustration
Pull both the left and right joysticks simultaneously towards either the
lower inside or lower outside points. Maintain this position for 3
seconds to lock the motors.
Never lock the motors in flight unless there is an emergency as the
drone will crash to the ground and may injure somebody.
Alternatively, once the drone has landed smoothly, pull the throttle stick
to the lowest position for 5 seconds to stop the motors.
Locking (stopping) the Motors ( Operate cautiously ）
In GPS mode, if the number of satellites is insufficient, the motors will not unlock and the FPV screen
will display a warning message.
Motors cannot be unlocked in Circle mode.
The motors can be unlocked in ATTI mode even if there is no GPS fix however no Home Point will be
recorded for the Return to Home function.
OR
1. Check that the drone is correctly assembled, propellers are tight and the main hatch is sealed.
2. Power on the remote control, followed by the drone.
3. Wait for the FPV screen to display the camera's live video and the OSD flight data. Check that the flight
display is normal.
4. Place the drone on a flat open surface or on the surface of the water.
5. Check the following flight data: Battery voltage > 12.5volts, Satellites > 9, Compass indicates the drone’s
current compass direction.
6. For safety, you should stand upwind and to the side of the drone and at least 3 meters away.
7. Arm the drone then push the THROTTLE joystick up slowly, allowing the drone to take off smoothly.
Release the throttle when the drone is approximately 1.5m high. Allow the drone to hover for a moment
to ensure flight stability. Always use gradual, smooth joystick movements.
8. When you need to descend, slowly pull down the throttle joystick allowing the drone to descend and
land on a flat surface or on the water.
9. After safely landing, keep the throttle down in its lowest position for at least 5 seconds until the motors
have stopped or use the disarm joystick command.
10. Stop recording video before powering off the drone, followed by its remote controller.
Basic Flight Steps